Skip to content
  • There are no suggestions because the search field is empty.

Wig dryer operational instructions

Collins Manufacturing Company
Operational Instructions
WD-1 Collins Wig Dryer

The WD-1 unit is to be installed by a qualified electrician and must meet all local codes
at the time of install. This unit is to be operated by qualified professional personal ONLY.

Any repairs to be done by qualified personnel only.

Do not service unit before disconnecting power. Do not operate if any safety has been bypassed.

Do not operate unit with doors open. Do not operate empty unit.
This unit is for drying wigs/mannequins designed for cosmetology use.
NO OTHER OBJECTS ARE TO BE DRIED IN THIS UNIT.

  • Towel dry all wigs and or mannequins before placing in dryer.
    Note: Wigs/mannequins should not be dripping water inside unit. Never dry wigs/mannequins with any product left on hair. Only clean hair is to be placed inside dryer.
  • Place mannequin heads in dryer. If not full, be sure to evenly distribute mannequin heads.
  • Close doors.
  • Select desired drying time on timer Note: Do not turn past stop. Do not turn off manually. Allow timer to count down to zero. The dryer has a cool down cycle to prevent damage to heating unit.
  • When the cycle is complete, check mannequins for desired level of dryness. Drying times will vary with hair types and quantity of mannequins.
    Note: More than one cycle may be required to completely dry all mannequins.


Collins Manufacturing Company
2000 Bowser Road · Cookeville, TN 38506
800.292.6450 · www.CollinsMfgCo.com

CAUTION!

MAINTENANCE

  • Daily, wipe down outside of cabinet with soft, damp (water) cloth.

  •  

    Keep any accumulated water cleaned up inside the unit, never allow water to set in unit.

  •  

    Any work inside heater box assembly is to be performed by qualified personnel only.