Skip to content
  • There are no suggestions because the search field is empty.

Tilting Shampoo Bowl Tilt Mechanism and Drain Assembly Installation

This step-by-step tutorial explains the process of installing a tilt mechanism on a shampoo bowl, specifically the CB82 model. The guide covers inspecting and preparing the bowl, assembling the drain, and properly installing the tilt mechanism, ensuring a secure and functional setup. Follow these steps to complete the installation for a tilt-mounted shampoo bowl.

 

Step-by-Step Guide:

1. Inspect the Tilt Mechanism and Bowl

  • Check the Inserts:
    • Before installation, inspect the tilt mechanism and the bowl. Ensure that the inserts fit snugly but are not too tight. If needed, clean the holes using a Dremel with a diamond bit to clear any factory buildup. This ensures the inserts will fit properly and securely hold the tilt mechanism.

2. Prepare the Drain

  • Loosen the Assembly:
    • Loosen the threaded assembly of the drain and apply a drop of Loctite on the male threads. This step helps prevent the drain assembly from loosening or falling off over time.
  • Disassemble the Drain:
    • Remove the center screw assembly to disassemble the drain. The drain consists of four parts: one piece goes inside the bowl, and one goes outside.
  • Install the Drain:
    • Ensure the rubber gasket stays inside the drain assembly.
    • Insert the rubber ring into the hole from the bottom of the bowl.
    • Align the gasket and center it correctly.
    • Place the outer piece of the drain on top and tighten everything down securely using a large screwdriver or wrench.

3. Install the Tilt Mechanism

  • Check and Clean the Holes:
    • Ensure that the holes in the bowl are clear and clean, as you did earlier with the inserts. This ensures smooth installation of the tilt mechanism.
  • Position the Springs:
    • Place the tilt mechanism so that the springs are located toward the front of the bowl, where the openings are.
  • Insert the Tilt Mechanism:
    • Carefully insert the tilt mechanism into place. Use the inserts to attach the mechanism securely.

4. Attach the Clamshell

  • Install Half of the Clamshell:
    • For this step, only half of the clamshell is used initially. The other half will be installed later, after attaching the mechanism to the cabinet.

5. Secure the Tilt Mechanism

  • Tighten the Bolts:
    • Using a quarter-inch drive ratchet, reach through the holes and tighten the bolts in a cross pattern. This ensures an even and secure fit.
    • Tighten each bolt to 15-20 inch-pounds. This is a critical step to ensure the tilt mechanism holds firmly without over-tightening or damaging the bowl.

6. Final Assembly

  • Install the Second Half of the Clamshell:
    • Once all the bolts are tightened, install the other half of the clamshell around the tilt mechanism.
  • Attach the Tilt Mechanism to the Cabinet:
    • Finally, place the tilt mechanism on the cabinet, securing it properly for use.

Conclusion:

By following these steps, you have successfully installed the tilt mechanism onto the CB82 shampoo bowl. Ensuring proper inspection, securing the drain, and tightening the tilt mechanism bolts will provide a functional and durable setup for your salon equipment. After finalizing the installation, the tilt mechanism should operate smoothly for your shampoo bowl.