Skip to content
  • There are no suggestions because the search field is empty.

How to Mount a Mirror with Mirror Clips

This guide explains the step-by-step process for securely mounting a mirror to a wall or station using J clips. This preferred method avoids using adhesives to prevent ghosting effects on the mirror surface. The tutorial also highlights precautions to take during installation. Tool holders are often mounted inside cabinets using a French cleat system for easy installation and stability. This guide explains how to properly attach a tool holder to ensure it stays secure, even during frequent door use.

 

Materials Needed:

  1. Four J clips (included with your station or mirror setup)

  2. A mirror (flat or curved)

  3. Screwdriver or drill (as needed for securing J clips)

  4. Piece of cardboard (for protecting the mirror during installation)

Instructions:

Step 1: Prepare the Surface

  1. Identify the bottom surface where the mirror will rest:

    • It could be a purse ledge, backsplash, countertop, or similar.

  2. Ensure the surface is clean and level to support the mirror securely.

Step 2: Install the Bottom J Clips

  1. Take two J clips and position them on the bottom surface:

    • Align them evenly where the mirror will sit.

  2. Secure the J clips to the surface using screws. These clips will bear the mirror’s weight.

Step 3: Position the Top J Clips

  1. Take the other two J clips and temporarily position them above where the mirror’s top edge will be:

    • Leave them slightly loose so they can move up and out of the way during installation.

Step 4: Prepare the Mirror

  1. Lay the mirror flat on a soft surface or a piece of cardboard to prevent damage.

  2. If working on a hard floor (e.g., concrete or tile), place a piece of cardboard beneath the mirror to prevent cracking during handling.

Step 5: Install the Mirror

  1. Carefully lift the mirror and set its bottom edge into the installed bottom J clips.

  2. Hold the mirror steady and ensure it aligns properly with the wall or station.

Step 6: Secure the Top J Clips

  1. Slide the top J clips down firmly onto the mirror’s top edge.

  2. Tighten the screws on the top J clips to lock the mirror securely in place.

Step 7: Final Check

  1. Ensure the mirror is stable and properly aligned.

  2. Gently test the setup to confirm the clips hold the mirror securely.

Tips and Warnings:

  • Avoid adhesives: Using adhesives may create ghosting effects (swirls or marks visible in the mirror over time). Only use adhesives if required by local building codes.

  • Protect the mirror: Always place cardboard or another protective material under the mirror during handling to prevent accidental cracking.

  • Handle with care: Mirrors are fragile. Ensure no hard surfaces touch the mirror during installation.

By following these steps, you’ll have a securely mounted mirror that looks great and stays in place. If you encounter issues, consult your station or mirror’s manufacturer for additional guidance.